60 ScreenPRO-II Controller • User’s Guide
3. Hardware Installation
Connection Charts
táÇÉëÅêÉÉå==Ô=p~ãéäÉ=asf=`çååÉÅíáçå=`Ü~êí
Each ScreenPRO-II has two DVI inputs for the Background and DSK (BG/DSK in A and
BG/DSK in B). Widescreen backgrounds will typically originate from a multi-head graphics
card, while single screen backgrounds are typically distributed from one computer through
a DA or signal splitter. Use the following chart to map your
Background and DSK DVI
connections:
táÇÉëÅêÉÉå=Ô=p~ãéäÉ=pí~åÇ~êÇ=aÉëíáå~íáçå=`Ü~êí
The ScreenPRO-II Controller enables you to configure up to four standard destinations.
Use the following chart to map the distribution of each destination, the usage of
BlendPRO-II if required, and the routing of your additional program and preview outputs:
Table 3-4. Sample DVI Connection Chart
Background DVI Routing
Source
Multi-Head
Graphics Card
Out
DA
(or Splitter)
Connects to: Note
Computer 1
3
1 ScreenPRO-II #1, BG/DSK In A Widescreen BG
3
2 ScreenPRO-II #2, BG/DSK In A Widescreen BG
3
4
Computer 2 1
3
ScreenPRO-II #1, BG/DSK In B Single screen DSK
2
3
ScreenPRO-II #2, BG/DSK In B Single screen DSK
3
4
Table 3-5. Sample Standard Destination Connection Chart
Standard Destinations
Output Dest Screen BlendPRO-II Channel Notes
ScreenPRO-II #1 Pgm DVI 1 Widescreen left 1 R12+
ScreenPRO-II #1 Pgm Analog 1 VGA 1
ScreenPRO-II #1 Pgm Analog 2
ScreenPRO-II #1 Pvw VGA 2
ScreenPRO-II #2 Pgm DVI 2 Widescreen right 2 R12+
ScreenPRO-II #2 Pgm Analog 1 VGA 3
ScreenPRO-II #2 Pgm Analog 2
ScreenPRO-II #2 Pvw VGA 4
Comments to this Manuals