Barco BlendPRO-II Instruction Manual download pdf (Page 223)

ScreenPRO-II Controller • User’s Guide 223

6. Operations

Working with Destinations

`äÉ~êáåÖ=aÉëíáå~íáçåë

 Use the following steps to clear destinations:

1. To clear all destinations, double-punch the All button.

2. To clear a single destination (or multiple destinations) from an active group, turn

DEST AUX on or off as desired, then simultaneously press the destinations that

you want

to remain on.

S Destinations 1, 2 and 3 are active. To clear destination 2, simultaneously

press destinations

1 and 3.

oçìíáåÖ=pçìêÅÉë=íç=aÉëíáå~íáçåë

When routing sources to both standard and Aux destinations, please note:

• Remember that the Destination/Aux Bus is one bus — it is not two separate and

independent buses.

• Any source that you select will apply to all enabled buses — even if that bus is not

currently visible (due to the state of the

DEST AUX button).

• Any transition that you perform will apply to all enabled buses — even if that bus is

not currently visible (due to the state of the

DEST AUX button).

 Use the following steps to route a source to a destination (or multiple destinations):

1. On the Destination/Aux Bus, enable or disable the DEST AUX button as

desired.

2. Enable only the destination button(s) on which you want to pend a route.

3. For "standard" destinations, select the desired layer (LAYER A or LAYER B).

This step is not required for an Aux bus route.

4. On the Source Selection Bus, select the source that you want to route to the

selected destination(s).

5. Repeat steps 1 through 3 for additional source-to-destination combinations.

6. Enable all destinations that you want to transition.

7. Perform the desired transition in the normal manner. Once performed, the

pending route is completed.

All

Note

At this point, the route is pending on Preview. You are free to

manipulate the source

(e.g., PIP and Key), but the route will

not occur until the destination is enabled, and the next

transition is performed.

Note

If you want to clear the pending route prior to performing it,

simply clear the lit Aux destination(s).

1 2 ... 218 219 220 221 222 223 224 225 226 227 228 ... 291 292

Comments to this Manuals

No comments

Barco BlendPRO-II Instruction Manual Page 223

Comments to this Manuals

Related products and manuals for Processors Barco BlendPRO-II