Barco BlendPRO-II Instruction Manual download pdf (Page 73)

ScreenPRO-II Controller • User’s Guide 73

3. Hardware Installation

System Installation

póëíÉã=fåëí~ää~íáçå

This section provides instructions for installing your ScreenPRO-II Controller system. If

required, use the two previous sample system diagrams for reference:

• Refer to “Figure 3-1” on page 58 for an illustration of a Sample System with

External Routing

• Refer to “Figure 3-2” on page 62 for an illustration of a Sample System with

Internal Routing

You will need one (or more) of the items listed below:

 Use the following steps to install ScreenPRO-II Controller:

1. Follow the unpacking procedures as listed in the “Unpacking and Inspection”

section on page 54.

2. As required, refer to the “Physical and Electrical Specifications” section on

page 258 in Appendix A for electrical and mechanical details.

3. As required, refer to the “ScreenPRO-II Controller Rear Panel” section on

page 32 in Chapter 2 for the locations of all connectors.

4. If you are rack mounting peripheral equipment such as the BlendPRO-II and

MatrixPRO routers, follow the rack mount procedures as outlined in each

individual User’s Guide.

Table 3-19. Equipment List, ScreenPRO-II Controller System

Qty. Item Note

1 ScreenPRO-II Controller chassis Required

1-4 ScreenPRO-II Required, quantity based on production and screen requirements

1-4 Video projector Required, quantity based on single or widescreen requirements

1-4 Analog monitor(s) Preview, quantity based on single or widescreen requirements

1-4 Analog or digital monitor(s) Program, quantity based on single or widescreen requirements

1 Ethernet hub or switch Customer supplied

TBD Ethernet cables Customer supplied

TBD Video cables Customer supplied (Genlock, Genlock Loop, Widescreen Lock)

1 Analog router Required for systems configured for external routing

1 Digital router Required for systems configured for external routing

1 BlendPRO-II Required for systems configured for widescreen blends

TBD Discreet analog sources Required for systems configured for internal routing

TBD Discreet digital sources Required for systems configured for internal routing

TBD PC(s), Mac(s) Required for BG and DSK DVI sources, and discreet RGB sources

TBD DA(s) Required for signal distribution, when internal routing utilized

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 291 292

No comments

Barco BlendPRO-II Instruction Manual Page 73