184 ScreenPRO-II Controller • User’s Guide
5. System Setup
Setup Prerequisites
pÉíìé=mêÉêÉèìáëáíÉë
Before starting to set up your ScreenPRO-II Controller system, please review the following
important prerequisites:
• Ensure that you are familiar with all ScreenPRO-II Controller system hardware,
including all Controller sections, and the functions of all buttons within the
sections. Refer to Chapter 2, “
Hardware Orientation” on page 31 for details.
• Ensure that hardware is properly installed, and that all sources, routers and
peripherals are properly connected. Refer to Chapter 3, “
Hardware Installation”
on page 53 for details.
• If you will be using a widescreen configuration, ensure that all “Widescreen Lock”
connections to/from BlendPRO-II are properly installed. In Chapter 3, refer to the
“
BlendPRO-II Widescreen Lock Connections” section on page 77 for details.
• Ensure that you are familiar will all ScreenPRO-II Controller menus and sub-
menus. Refer to Chapter 4, “
Menu Orientation” on page 85 for details.
• Ensure that your connection charts are complete, and readily available for
reference throughout this chapter. In Chapter 3, refer to the “
Connection Charts”
section on page 56 for details.
Please note:
• In this chapter, when a procedure tells you to “scroll to” a certain line, use the
rotary knob labelled
NAV to move the highlight.
• When a procedure tells you to “adjust” or “select” a certain parameter, use the
ADJ rotary knob.
Figure 5-1. Menu Navigation
452
-34
N
A
V
70
A
D
J
0.8
[ LINEAR ]
674
Comments to this Manuals