Barco BlendPRO-II Instruction Manual download pdf (Page 195)

ScreenPRO-II Controller • User’s Guide 195

5. System Setup

AUX Destination Setup

20. Repeat from step 6 for the next router that you wish to assign.

21. When you have configured all of your system’s routers, on the Router

Specification Menu

, scroll to the Number line, and scan through the remaining

router numbers. Other than the ones which you just assigned, if there are

any

router numbers that do not say

<EMPTY> on the Number line, press {DELETE

ROUTER

} to remove the specification from the system.

22. Press {BACK} to return to the System Menu.

23. Press {HOME} to return to the Home Menu.

24. Press SAVE to save the current configuration.

^ru=aÉëíáå~íáçå=pÉíìé

ScreenPRO-II Controller system setup: Step 9

In this procedure, you will set up the system’s Aux (Auxiliary) destinations.

S Prerequisites — Ensure that you are familiar with the following menus:

~ Destination Setup Menu. In Chapter 4, refer to the “Destination Setup

Menu” section on page 117.

~ Aux Destination Setup Menu. In Chapter 4, refer to the “Aux

Destination Setup” section on page 120.

The following topics are discussed:

• Aux Destination Overview

• Aux Destination Setup

• ImagePRO or PrePRO-II Aux Destination Setup

^ìñ=aÉëíáå~íáçå=lîÉêîáÉï

The ScreenPRO-II Controller system provides three types of Aux destinations — Aux,

ImagePRO Aux and PrePRO-II Aux. Each type of destination can be switched from the

ScreenPRO-II Controller by selecting it on the

Destination Bus, then selecting the desired

source on the

Source Selection Bus.

• An Aux destination is the output of a router, which is typically connected directly to

a monitor — rather than to the ScreenPRO-II. This type of destination is single

format (e.g., an analog monitor can only accept signals from an analog router).

• An ImagePRO Aux destination is an external ImagePRO, a multi-format

processor with three inputs (one analog, one SDI and one DVI) and the ability to

scale these inputs to one common output format. Typically, the ImagePRO output

is connected to another display device such as a monitor or projector.

• A PrePRO-II Aux destination is an external PresentationPRO-II, a multi-format

processor with nine inputs (eight analog and one SDI), and the ability to scale

these inputs to one common output format. Similar to ImagePRO, the PrePRO-II

output is connected to another display device such as a monitor or projector.

Note

Up to 4 “Aux” destinations can be assigned. These are

accessible by pressing the red

DEST AUX button.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 291 292

Comments to this Manuals

No comments

Barco BlendPRO-II Instruction Manual Page 195

Comments to this Manuals

Related products and manuals for Processors Barco BlendPRO-II