Barco BlendPRO-II Instruction Manual download pdf (Page 193)

ScreenPRO-II Controller • User’s Guide 193

5. System Setup

Router Setup

oçìíÉê=pÉíìé

ScreenPRO-II Controller system setup: Step 8

In this procedure, you will set up the system’s routing switchers.

S Prerequisites — Ensure that you are familiar with the following menus:

~ Router Specification Menu. In Chapter 4, refer to the “Router

Specification Menu” section on page 127.

~ Comm Setup Menu. In Chapter 4, refer to the “Comm Setup Menus”

section on page 129.

~ Output Patch Menu. In Chapter 4, refer to the “Output Patch Menu”

section on page 132.

 Use the following steps to set up your system’s routers:

1. Ensure that your router(s) are properly connected to the ScreenPRO-II Controller

system. In Chapter 3, refer to the “

System Installation” section on page 73.

2. For Ethernet controlled routers, ensure that your router’s protocol is supported.

The list of supported manufacturers currently includes the Folsom MatrixPro

series, and routers from Sierra, Extron, Leitch, Isis, DVILink and DPI.

3. For Ethernet controlled routers, ensure that you know each router’s IP address. If

required, preset IP addresses at the routers themselves. Refer to each router’s

User’s Guide for instructions.

Please note that

MatrixPRO routers default to the following IP addresses:

~ MatrixPRO Analog Router: 192.168.0.241

~ MatrixPRO SDI Router: 192.168.0.242

From the Home Menu, press SYSTEM to access the System Menu.

5. Press {ROUTER SETUP} to display the Router Specification Menu.

6. On the Number line, select the number of the router that you wish to configure.

7. On the Manufacturer line, select the router manufacturer.

8. On the Router Type line, select the type of router being used.

9. On the Number of Inputs line, select the router’s input count.

10. On the Number of Outputs line, select the routers’ output count.

11. On the Communication Type line, select the type of communication that you are

using to connect to the router.

12. Press {COMM SETUP} to display the appropriate Comm Setup Menu for the

selected device.

13. For Ethernet controlled routers, verify that the IP Address field matches the

router’s IP address. If not, use the

ADJ knob in conjunction with the {NEXT IP

QUAD

} button to change the address as required.

14. Test communications:

~ For serial and Ethernet controlled routers, press {TEST COMM}.

~ For Lantronix devices, press {DISCOVER LTRX}.

If the message “Communication Failed” appears, take the necessary actions to

rectify the error and repeat this step as required.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 291 292

Comments to this Manuals

No comments

Barco BlendPRO-II Instruction Manual Page 193

Comments to this Manuals

Related products and manuals for Processors Barco BlendPRO-II