212 ScreenPRO-II Controller • User’s Guide
5. System Setup
LOGO Setup Procedure
8. On the Key Type line, select the type of key desired (Luma or Color).
9. Adjust key parameters as required:
~ For a Luma Key, adjust Invert Mode, Clip, Gain, Opacity and Fill
Source
for the optimum visual key.
~ For a color key, pick the desired color, then adjust Red, Green and Blue
Color
, Threshold, Mask and Opacity.
10. When your DSK is fully adjusted, press {HOME} to return to the Home Menu.
11. Press {SAVE} to save the new system configuration in memory.
ildl=pÉíìé=mêçÅÉÇìêÉ
ScreenPRO-II Controller system setup: Step 18
S Prerequisites — Ensure that you are familiar with the LOGO Menu. In
Chapter 4, refer to the “
LOGO Menu” section on page 182.
In this procedures, you will set up the system’s LOGO. Remember that the LOGO can be
configured as black or as a frame grab.
Use the following steps to set up the LOGO:
1. On the Destination Bus, select the destination whose LOGO you want to
configure.
2. On the ScreenPRO-II Controller console, press LOGO to display the LOGO
Menu
.
3. To configure a black LOGO:
a. Scroll to the Type line and select Black.
4. To configure a frame grab LOGO:
a. Ensure that you have captured a still frame, either from a live DVI
background or from one of the two layers (
LAYER A or LAYER B). In
Chapter 6, refer to the “
Working with Still Frames” section on page 246
for instructions.
b. Scroll to the Type line and select FG_1, FG_2 or FG_3.
18
Comments to this Manuals