Barco BlendPRO-II Instruction Manual download pdf (Page 40)

40 ScreenPRO-II Controller • User’s Guide

2. Hardware Orientation

Front Panel Sections

Next — press to recall the next valid Preset in sequential order. Please note:

• If Preset 2 is lit, pressing Next recalls Preset 3.

• If Preset 6 is active on page 2, pressing Next advances to Preset 1 on page 3.

• If a Preset is undefined, it will be skipped when Next is pressed.

Previous — this function is currently not implemented.

Page — hold down Page, then press the desired Preset button to switch to that page of

Presets. The

Red LED above the button lights to indicate the selected page.

S To switch to page 5, press Page + 5.

In Chapter 6, refer to the “

Working with Presets” section on page 243 for complete

instructions on all Preset modes.

aÉëíáå~íáçåL^ìñ=_ìë

The figure below illustrates the Destination/Aux Bus:

Figure 2-4. Destination/Aux Bus

Each numbered button on the Destination Bus represents a location to which you can

route

some form of controller (or router) output. The transitions that you perform will affect

the selected destinations only, leaving the unselected destinations as they were. The

ScreenPRO-II Controller provides eight destinations — four standard (e.g., projectors) and

four Aux (auxiliary).

Page

Note

The Page button is also used (in conjunction with the ALL

button) to lock and unlock the Controller. In Chapter 6, refer

to the “

Locking and Unlocking the Controller” section on

page 252 for details.

1 2 3 4

DEST

AUX

DESTINATIONS / AUX

ALL

Important

Operationally, remember that the Destination/Aux Bus is

one bus — it is

not two separate and independent buses.

• Any source selection will apply to all enabled buses.

• Any transition will apply to all enabled buses.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 291 292

No comments

Barco BlendPRO-II Instruction Manual Page 40