Barco BlendPRO-II Instruction Manual download pdf (Page 194)

194 ScreenPRO-II Controller • User’s Guide

5. System Setup

Router Setup

15. Press {BACK} to return to the Router Specification Menu.

16. Press {OUTPUT PATCH} to display the Output Patch Menu for the selected

router. On the top line, note the router name and confirm that this is the router that

you wish to patch.

The table below illustrates the default output patch table (as configured after a

factory reset). The table is valid for both analog and digital routers.

If you have a

Folsom MatrixPRO Router and you have connected the router

outputs per the table above,

no setup is necessary on the Output Patch Menu —

unless you specifically want to patch the outputs in a different manner. This

“default” configuration is ideal for most single and widescreen applications.

17. To “custom” patch router outputs, use the following steps:

a. On the Router Output line, select the output that you want to patch.

b. If you are uncertain about the current patch, or if you want to remove the

current (existing) patch and start clean, press {

DELETE PATCH}.

c. On the Device ID line, select the ScreenPRO-II ID to which you want to

patch the selected router output.

d. On the SP Input line, select the specific ScreenPRO-II input to which

you want to patch the selected router output.

e. Press {ADD PATCH} to confirm your changes. The new “mapping”

appears on the menu.

f. Repeat step 17 to patch additional outputs.

18. To designate a router output as an “Aux” output:

a. On the Router Output line, select the specific router output that you

want to designate as an Aux output.

b. If you are uncertain about the current patch, or if you want to remove the

current (existing) patch and start clean, press {

DELETE PATCH}.

c. On the Device ID line, select None.

d. Press {ADD PATCH} to confirm the change.

e. Repeat step 18 to designate additional Aux outputs.

19. Press {BACK} to return to the Router Specification Menu.

Table 5-1. Default Output Patch Table

Router Output ScreenPRO-II ID

ScreenPRO-II Input

(Analog or SDI)

11 1

21 2

32 1

42 2

53 1

63 2

74 1

84 2

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 291 292

Comments to this Manuals

No comments

Barco BlendPRO-II Instruction Manual Page 194

Comments to this Manuals

Related products and manuals for Processors Barco BlendPRO-II