Barco BlendPRO-II Instruction Manual download pdf (Page 242)

242 ScreenPRO-II Controller • User’s Guide

6. Operations

Working with Transitions

d. Adjust the Transition Edge field for the desired wipe edge.

3. In the Transition Section, press WIPE.

4. Press AUTO TRANS to wipe the setup to Program.

j~åì~ä=qê~åëáíáçåë

Any of the transitions outlined above can be performed manually with the T-Bar.

 Use the following steps to perform a manual transition:

1. Set up the desired “look” in Preview.

2. Select WIPE or MIX as desired. Remember that wipes can only be performed on

single screen destinations

3. In the Transition Section, move the T-Bar to manually dissolve (or wipe) the

images on Preview to Program.

qê~åëáíáçå=kçíÉë

Using the Effects Menu, transitions performed on the ScreenPRO-II Controller are

destination-based. Two examples are provided below.

S Select destinations 1 and 3, then press WIPE. Next, select destination 2 only

and press

MIX. Finally, select all three destinations and press AUTO TRANS

to simultaneously perform a wipe on destinations 1 and 3, and a dissolve on

destination 2.

S If destinations 1, 2 and 3 are lit, and both the WIPE and MIX buttons are lit,

pressing

MIX changes all three destinations to MIX.

Note

Key Frame effects are fixed as LINEAR, and cannot be

changed.

Note

In the above example, both the WIPE and MIX buttons would

be lit when all three destinations are selected.

1 2 ... 237 238 239 240 241 242 243 244 245 246 247 ... 291 292

No comments

Barco BlendPRO-II Instruction Manual Page 242