Barco BlendPRO-II Instruction Manual download pdf (Page 231)

ScreenPRO-II Controller • User’s Guide 231

6. Operations

Working with Layers

~ Press Full Screen to bring the PIP to full screen, using the source’s

height as the defining factor.

~ Press Freeze to freeze the PIP (on both Program and Preview). Press

again to unfreeze.

10. Transition — Transition the new look to program with a CUT or AUTO TRANS.

Refer to the “

Working with Transitions" section on page 241 for details.

tçêâáåÖ=ïáíÜ=hÉóë=áå=péäáí=jçÇÉ

In Split Mode, the mixer’s two layers operate independently.

 Use the following steps to work with Keys in Split Mode.

1. In the Layer Control Section, ensure that the Split button is On.

2. Press the desired layer button (A or B). Please note:

~ The layer button blinks to indicate that it is active for modification.

~ In the Source Selection Bus, the source assigned to the layer blinks.

~ On Preview, the raster box for the selected layer blinks (even if it is

hidden under another layer).

3. In the Layer Functions Section, ensure that the KEY button is lit and the Key

is visible. If the menu is not visible, press KEY.

4. On the Source Selection Bus, select the desired (new) key source. The button

blinks to indicate that it is selected, and the source appears on Preview.

5. Adjust the Key’s type, clip, gain, opacity, fill, size, position, source image and

cropping. Refer to the “

Modifying Keys" section on page 233 for details.

6. Prior to the transition, you can set up an additional effect if desired in Split Mode:

~ To set up an additional “Split Mode” Key in Preview, repeat the

procedure from step 2.

~ To set up a PIP in Preview, refer to the “Working with PIPs in Split

Mode" section on page 229.

7. Press CUT or AUTO TRANS to transition the look to Program. Refer to the

“

Working with Transitions" section on page 241 for details.

8. Repeat the procedure from step 1 for the next transition.

Note

Even though this mode allows you to display two PIPs (or

Keys) on air, it is more restrictive. Once both layers are on

Program, you must transition them off Program, make

changes — and then transition them back on.

Note

Even if the layer is on Program, the Key Menu appears, but

parameters can not be adjusted.

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 291 292

Comments to this Manuals

No comments

Barco BlendPRO-II Instruction Manual Page 231

Comments to this Manuals

Related products and manuals for Processors Barco BlendPRO-II