ScreenPRO-II Controller • User’s Guide 51
2. Hardware Orientation
Front Panel Sections
CUT — press to instantly cut the images from Preview to Program.
Auto Trans — press to transition automatically from Preview to Program at a pre-defined
rate, using the selected transition type (
MIX or WIPE). Auto transition rates are defined
using the
Effects Menu.
T-Bar — enables you to perform smooth, manual transitions. Each time the T-Bar is
moved from limit to limit, the setup on Preview transitions to Program using the selected
transition type (
MIX or WIPE).
For additional information on transitions and the
Effects Menu:
• In Chapter 4, refer to the “Effects Menu” section on page 146 for menu details.
• In Chapter 6, refer to the “Working with Transitions” section on page 241 for
operational procedures.
CUT
AUTO
TRANS
Note
Because the Controller’s Effects Menu is destination-based,
WIPE and MIX effects can be assigned per destination.
For example, with destinations 1 and 3 lit, select
WIPE. Next,
with destination 2 lit, select
MIX. Next, select all three
destinations and press
AUTO TRANS to perform a wipe on
destinations 1 and 3, and a dissolve on destination 2.
Comments to this Manuals