Barco BlendPRO-II Instruction Manual download pdf (Page 49)

ScreenPRO-II Controller • User’s Guide 49

2. Hardware Orientation

Front Panel Sections

• If BG A is on Program and BG B is selected in Preview, BG A will dissolve, cut or

wipe to

BG B on the next transition.

• Toggle mode affects background transitions. In Chapter 6, refer to the

“

Background Transitions” section on page 227 for complete instructions.

Layer Buttons — press to select a layer on Preview for transition to or from Program.

• When lit and blinking:

~ The layer is active for manipulation.

~ A source can be assigned to the layer from the Source Selection Bus.

~ The layer can be assigned as a PIP or Key using the buttons in the

Layer Functions Section.

• When lit solid, the layer is on Preview, but it is not active for manipulation. It is,

however, ready to be transitioned to or from Program.

• When the Red LED above the button is lit, the layer is on Program.

• To clear a layer from Preview (so that it will transition off Program), press Clear

Layer

. This turns off the layer button. If the Red LED above the layer button is lit,

on the next transition the layer will transition off Program.

DSK — press to select the unscaled DSK on Preview for transition to or from Program.

The button lights when selected. Please note:

• When the Red LED above the button is lit, the DSK is on Program.

• The DSK and BG B are mutually exclusive.

LOGO — press to select the unscaled, full screen LOGO on Preview for transition to or

from Program. The button lights when selected. Please note:

• When the Red LED above the button is lit, the LOGO is on Program.

• The LOGO is the system’s highest priority layer. The LOGO “source” is selected

from one of the individual ScreenPRO-II’s three internal frame stores.

• The LOGO layer is often used as a “black preview” function. If Black is selected

as the “type” on the

Logo Input Setup Menu, you can fade to black at any time by

selecting

LOGO on preview. In Chapter 4, refer to the “LOGO Menu” section on

page 182 for details.

• The logo is not a live input, and does not have an associated key signal.

Clear Layer — press Clear Layer to remove the currently selected (blinking) layer from

Preview — in preparation for transitioning it off Program. In Chapter 6, refer to the

“

Clearing Layers from Program” section on page 234 for instructions.

Layer

DSK

LOGO

Important

All layers are maintained underneath the LOGO. For

example, if you have two PIPs and a DSK on Program when

you transition to the

LOGO, when you fade the LOGO off —

the previous “look” is still there.

Clear

Layer

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 291 292

Comments to this Manuals

No comments

Barco BlendPRO-II Instruction Manual Page 49

Comments to this Manuals

Related products and manuals for Processors Barco BlendPRO-II