ScreenPRO-II Controller • User’s Guide 275
`K==réÖê~ÇáåÖ=pçÑíï~êÉ
Ethernet Upgrade Method
8. Click the Connect button. If the connection is successfully, the message
“
Connect via Ethernet successful” appears in the Flash Loader’s Status Bar. If
you cannot connect, refer to the “
Troubleshooting Ethernet Communication”
section on page 275.
9. To upload files to the ScreenPRO-II Controller, click "Open script file to read and
upload
."
10. In the dialog, select "Complete_Load.sld" and click Open. The ScreenPRO-II
Controller menu should immediately display the "
System in LOADER MODE"
message.
11. It takes several minutes to load the flash memory. When complete, the Flash
Loader utility displays the “
Upload Complete” message. Click OK to continue.
12. Cycle power on the ScreenPRO-II Controller, and exit the Flash Loader utility.
13. On ScreenPRO-II Controller, perform a factory reset. In Chapter 5, refer to the
“
Return to Factory Default” section on page 189 for instructions.
14. On the ScreenPRO-II Controller, verify that the new software has been loaded
correctly. Press {
HOME} > SYSTEM > {SW VER} to display the Software
Version Menu
.
qêçìÄäÉëÜççíáåÖ=bíÜÉêåÉí=`çããìåáÅ~íáçå
Use the following steps to determine the IP address of ScreenPRO-II Controller, and
establish proper communications:
1. Turn on the ScreenPRO-II Controller. Press {HOME} > SYSTEM > {NETWORK
SETUP
} to display the Network Setup Menu.
2. Make a note of the IP address.
3. Attempt to ping the ScreenPRO-II Controller as follows:
a. Connect ScreenPRO-II Controller’s Ethernet port to a Hub or Switch.
b. Connect the Ethernet Hub or Switch to your PC. A totally “local” network
is recommended, without IP connections to the outside world.
c. Turn on the PC or laptop.
d. Open a command prompt window on the PC. Click Start > Programs >
Accessories > Command Prompt
.
e. On the command prompt line, type:
ping 192.168.0.2
... followed by Enter.
f. If the computer is able to successfully communicate with the
ScreenPRO-II Controller, you will see a series of “
replies” from the
target IP address. Repeat the upgrade procedure as outlined in the
“
Ethernet Upgrade Method” section on page 274.
Note
The default IP address is 192.168.0.2.
Note
Use the unit’s actual IP address, as determined in step 2
above.
Comments to this Manuals