Barco BlendPRO-II Instruction Manual download pdf (Page 197)

ScreenPRO-II Controller • User’s Guide 197

5. System Setup

AUX Destination Setup

7. On the Source Mapping line, two choices are available:

~ Select Input Patch if you want to map Aux sources according to how

inputs are patched to buttons on the

Source Selection bus. Note that

this is the typical choice.

~ Select Direct Map if you want the Source Selection bus to be a 1:1

mapping of your router inputs — for

this Aux destination only.

8. On the ID line, select the ID of the ImagePRO or PrePRO-II to which you want to

route Aux sources.

9. In the Analog section:

a. On the Analog Router Name line, select the router from which analog

sources will be routed to the ImagePRO (or PrePRO-II).

b. On the Analog Router Output line, select the specific router output that

you designated as an

Aux output.

c. On the ImagePRO Input (or PrePRO-II Input) line, select the

ImagePRO or PrePRO-II input to which the analog router output is

connected.

10. In the SDI section:

a. On the SDI Router Name line, select the router from which SDI sources

will be routed to the ImagePRO (or PrePRO-II).

b. On the SDI Router Output line, select the specific router output that you

designated as an

Aux output.

c. On the ImagePRO Input (or PrePRO-II Input) line, select the

ImagePRO or PrePRO-II input to which the SDI router output is

connected.

11. In the DVI section (applies to ImagePRO Aux destinations only):

a. On the DVI Router Name line, select the router from which DVI sources

will be routed to the ImagePRO.

b. On the DVI Router Output line, select the specific router output that you

designated as an

Aux output.

c. On the ImagePRO Input line, select the ImagePRO input to which the

DVI router output is connected.

12. Press {BACK} to return to the Destination Setup Menu.

13. Repeat from step 4 to configure another ImagePRO or PrePRO-II Aux

destination.

14. Press {BACK} to return to the System Menu.

15. Press {HOME} to return to the Home Menu.

16. Press {SAVE} to save the new system configuration in memory.

This completes the procedure for defining

ImagePRO or PrePRO-II Aux destinations. The

selected button(s) on the

Destination Bus are now active. Please note:

• For proper operation, ImagePRO and PrePRO-II devices must be connected to

the ScreenPRO-II Controller via Ethernet.

• ImagePRO and PrePRO-II output setups must be performed locally on the units

themselves.

• Only one router of each type (Analog, DVI and SDI) can be connected to an

ImagePRO unit.

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 291 292

Comments to this Manuals

No comments

Barco BlendPRO-II Instruction Manual Page 197

Comments to this Manuals

Related products and manuals for Processors Barco BlendPRO-II