Barco BlendPRO-II Instruction Manual download pdf (Page 207)

ScreenPRO-II Controller • User’s Guide 207

5. System Setup

Input Setup

e. Scroll to the Gamma line and set the input gamma.

f. Scroll to the Input Sync Type line and set the type of sync used by the

selected source.

g. Scroll to the Pulldown Compensation line and enable (or disable) the

mode.

h. Scroll to the Sync Slice <mv> line and adjust as required.

i. Scroll to the Sharpness line and set the input’s sharpness.

j. Press {SAVE} to save the input configuration.

8. Perform additional setups on the Aspect Ratio Menu — if required:

a. Press {AR} to display the Aspect Ration Menu.

b. Adjust the Mode and Ratio as required.

c. Press {SAVE} to save the input configuration.

d. Press {BACK} to return to the Input Menu.

9. Perform additional setups on the Sizing Menu — if required:

a. Press {SIZING} to display the Sizing Menu.

b. If 1:1 Sampling was selected:

• Scroll to the

Clock Phase line and set the system’s A/D

converter.

• Scroll to the

H Total line and set the total pixel count per line.

• Scroll to the

H Active line and set the width of the active area.

• Scroll to the

H Position line and set the start of the active

area’s horizontal offset from H sync.

• Scroll to the

V Active line and set the number of vertical lines in

the image.

• Scroll to the

V Position line and set the start of the active area’s

vertical offset from V sync.

•Press

{SAVE} to save the input configuration.

• Press

{BACK} to return to the Input Menu.

c. If Oversample was selected:

• Scroll to the

Right Edge line and adjust as required.

• Scroll to the

Left Edge line and adjust as required.

• Scroll to the

Top Edge line and adjust as required.

• Scroll to the

Bottom Edge line and adjust as required.

• Press {

SAVE} to save the input configuration.

• Press {

BACK} to return to the Input Menu.

10. Perform additional setups on the Color Balance Menu — if required:

a. Press {COLOR BALANCE} to display the Color Balance Menu.

b. If an RGB source was selected:

• Scroll to the

Red Contrast line and adjust as required.

• Scroll to the

Red Brightness line and adjust as required.

• Scroll to the

Green Contrast line and adjust as required.

• Scroll to the

Green Brightness line and adjust as required.

• Scroll to the

Blue Contrast line and adjust as required.

• Scroll to the

Blue Brightness line and adjust as required.

• Press {

SAVE} to save the input configuration.

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 291 292

Comments to this Manuals

No comments

Barco BlendPRO-II Instruction Manual Page 207

Comments to this Manuals

Related products and manuals for Processors Barco BlendPRO-II