ScreenPRO-II Controller • User’s Guide 109
4. Menu Orientation
System Menu
póëíÉã=jÉåì=aÉëÅêáéíáçå
The figure below illustrates a sample System Menu:
Figure 4-17. System Menu (sample)
To access the menu:
• Press SYSTEM on the Home Menu.
The
System Menu provides the following functions:
• Modify Layers On Program — when enabled, you can change PIPs and Keys
directly on Program, without first setting up your “look” on Preview. When
disabled, Preview must be used to set up the next look. In Chapter 6, refer to the
“
Working with Still Frames” section on page 246 for details.
• Tally Mode — enables or disables the tally function. When enabled, all eight
tallies are activated, and can be triggered by pressing a source button. When
disabled, all tallies are deactivated (but tally setups remain as configured).
~ Refer to the “Input Source Patch Menu” section on page 125 for details
on assigning tallies to sources.
~ In Chapter 6, refer to the “Working with Tallies” section on page 253 for
tally operating instructions.
• Press {RESET} to display the System Reset Menu. Refer to the “System Reset
Menu” section on page 111 for details.
• Press {SW VER} to display the Software Version Menu. Refer to the “Software
Version Menu” section on page 112 for details.
• Press {DIAG} to display the Diagnostics Setup Menu. Refer to the
“
Diagnostics Setup Menu” section on page 113 for details.
• Press {DEST SETUP} to display the Destination Setup Menu. Refer to the
“
Destination Setup Menu” section on page 117 for details.
• Press {NETWORK SETUP} to display the Network Setup Menu. Refer to the
“
Network Setup Menu” section on page 124 for details.
H
O
M
E
N
A
V
A
D
J
SYSTEM MENU
SW
V
E
R
DEST
SETUP
ROUTER
SETUP
D
I
A
G
R
E
S
E
T
NETWORK
SETUP
Modify Layers On Program Off
Tally Mode Off
INPUT
PATCH
Comments to this Manuals