Barco BlendPRO-II Instruction Manual download pdf (Page 46)

46 ScreenPRO-II Controller • User’s Guide

2. Hardware Orientation

Front Panel Sections

i~óÉê=cìåÅíáçåë=pÉÅíáçå

The figure below illustrates the Layer Functions Section.

Figure 2-7. Layer Functions Section

The buttons in the Layer Functions Section enable you to change or modify the selected

(blinking) layer in the

Layer Control Section.

PIP — press to change the selected layer (in the Layer Control Section) and its

associated source to a PIP. The

PIP Adjustment Menu appears on the Touch Screen. In

Chapter 4, refer to the “

PIP Adjustment Menu” section on page 148 for details.

Key — press to change the selected layer (in the Layer Control Section) and its

associated source to a Key. The

Key Adjustment Menu appears. In Chapter 4, refer to

the “

Key Menu” section on page 155 for details.

Full Screen — press to take the active PIP or Key to full screen. In each case, the

source’s height is used as the parameter that defines the full screen size.

S If a source’s original dimension is 1280 x 1024, pressing Full Screen

expands (or reduces) the PIP or Key to fill the output screen vertically. If

borders are

ON, they will be taken into account so that they are visible.

In Chapter 6, refer to the “

Using Full Screen” section on page 235 for instructions.

Clone — for widescreen configurations only, press to make an exact copy of a layer onto

the opposite screen. All parameters of the PIP or Key are cloned, including the source’s

shadow, key effects, border and size. Once cloned, you can select between a “mirror” or

an “offset” clone.

S If Layer A is a PIP on screen 1, press Clone to make an exact copy of the

PIP on screen 2. When you adjust the PIP, both the original and the “cloned”

copy are adjusted simultaneously.

In Chapter 6, refer to the “

Using Clone” section on page 235 for instructions.

Swap Z-order — press to change the visual priority (on Preview) of the two mixer layers.

The PIPs or Keys remain at their current locations — only the priority changes.

S If the PIP on Layer B is visually on top of the PIP on Layer A, press

Swap Z-Order to place Layer A’s PIP on top.

In Chapter 6, refer to the “

Using Swap Z-Order” section on page 236 for instructions.

PIP KEY

Full

Screen

Clone

Swap

Z-Order

Move

Setup

Move

Mix

Source

Swap Toggle Freeze

LAYER FUNCTIONS

PIP

KEY

Full

Screen

Clone

Swap

Z-order

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 291 292

Comments to this Manuals

No comments

Barco BlendPRO-II Instruction Manual Page 46

Comments to this Manuals

Related products and manuals for Processors Barco BlendPRO-II