Barco BlendPRO-II Instruction Manual download pdf (Page 41)

ScreenPRO-II Controller • User’s Guide 41

2. Hardware Orientation

Front Panel Sections

Examples of destinations are listed below:

• Single Screen Destination — this is a “single projector” destination that takes its

input from a ScreenPRO-II.

• Wide Screen Destination — this is a “multiple projector” destination that takes its

inputs from two, three or four ScreenPRO-IIs, as routed through a BlendPRO-II.

• Aux Destination — this is a single monitor that takes its input from one router

output (in a single format). When you select an Aux destination and a source on

the Controller, you are talking

directly to a specific router output via RS-232 or

Ethernet communications — and making a source-to-destination connection.

• ImagePRO Aux Destination — this is a standalone ImagePRO that takes its

input(s) from multiple routers, in multiple formats. When connected to a single

monitor or projector, a scaled output signal is provided — in one format. Whereas

Aux Destination requires a single input format, an ImagePRO Aux Destination

accepts inputs in multiple formats.

• PresentationPRO-II Aux Destination — similar to an ImagePRO Aux

destination, this is a standalone PresentationPRO-II that takes its input(s) from

standalone sources or routers, in multiple formats. When connected to a single

monitor or projector, a scaled signal is provided in one format.

In Chapter 5, refer to the “

Standard Destination Setup” section on page 192 for details on

all destination setup procedures.

Following are descriptions of each button’s function.

Destination/Aux Buttons — press to toggle the numbered destination on or off. Any

combination of destinations can be selected. The transitions that you perform will affect

only the selected destination(s). Please note:

• The four destination buttons work in conjunction with the DEST/AUX button. See

the description of the

DEST/AUX button (immediately below) for details.

• Press a numbered destination button by itself to enable that destination and

toggle all other destinations off. In this mode, the buttons are mutually exclusive.

• Press two or more destination buttons simultaneously to enable a “group” of

destinations. In this mode, the selected group is mutually exclusive with any other

active destinations:

S Destinations 1, 2 and 3 are lit. If you press destinations 1 and 2

simultaneously (to enable them), destination

3 turns off.

• Use the All button to turn all destinations on or off. See the description of the All

button (below) for details.

DEST/AUX — press to switch the bus between standard (projector) destinations and Aux

(auxiliary) destinations, such as monitors.

• When DEST/AUX is off, you are selecting standard (projector) destinations.

• When DEST/AUX is lit, you are selecting Aux (auxiliary) destinations.

DEST

AUX

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 291 292

Comments to this Manuals

No comments

Barco BlendPRO-II Instruction Manual Page 41

Comments to this Manuals

Related products and manuals for Processors Barco BlendPRO-II