Barco BlendPRO-II Instruction Manual download pdf (Page 229)

ScreenPRO-II Controller • User’s Guide 229

6. Operations

Working with Layers

tçêâáåÖ=ïáíÜ=mfmë=áå=péäáí=jçÇÉ

In Split Mode, the mixer’s two layers operate independently.

 Use the following steps to work with PIPs in Split Mode.

1. In the Layer Control Section, ensure that the Split button is On.

2. Press the desired layer button (A or B). Please note:

~ The layer button blinks to indicate that it is active for modification.

~ In the Source Selection Bus, the source assigned to the layer blinks.

~ On Preview, the raster box for the selected layer blinks (even if it is

hidden under another layer).

3. In the Layer Functions Section, ensure that the PIP button is lit and the PIP

Adjustment Menu

is visible. If the menu is not visible, press PIP.

4. On the Source Selection Bus, press the button for the desired (new) source.

The button blinks to indicate that it is selected, and the source appears within the

PIP on Preview.

5. Adjust the PIP’s size, position, border, shadow, source image, cropping and

special effects. Refer to the “

Modifying PIPs" section on page 230 for details.

6. Prior to the transition, you can set up an additional layer if desired in Split Mode:

~ To set up an additional “Split Mode” PIP in Preview, repeat the

procedure from step 2.

~ To set up a Key in Preview, refer to the “Working with Keys in Split

Mode" section on page 231.

7. Press CUT or AUTO TRANS to transition the look to program. Refer to the

“

Working with Transitions" section on page 241 for details.

8. Repeat the procedure from step 1 for the next transition.

tçêâáåÖ=ïáíÜ=mfmë=áå=jáñ=jçÇÉ

In Mix Mode, the mixer’s layers are ganged together. Both PIPs can be perfectly co-

located on screen (

Mix Source mode), or both can operate independently (Swap mode),

but only one PIP can be on Program at a time.

 Use the following steps to work with PIPs in Mix Mode.

1. In the Layer Control Section, ensure that the Split button is Off.

2. Press the desired layer button (A or B). Please note:

~ The layer button blinks to indicate that it is active for modification.

~ In the Source Selection Bus, the source assigned to the layer blinks.

Note

Even though this mode allows you to display two PIPs (or

Keys) on air, it is more restrictive. Once both layers are on

Program, you must transition them off Program, make

changes — and then transition them back on.

Layer

Note

Even if the layer is on Program, the PIP Adjustment Menu

appears, but parameters can not be adjusted.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 291 292

Comments to this Manuals

No comments

Barco BlendPRO-II Instruction Manual Page 229

Comments to this Manuals

Related products and manuals for Processors Barco BlendPRO-II