Barco BlendPRO-II Instruction Manual download pdf (Page 123)

ScreenPRO-II Controller • User’s Guide 123

4. Menu Orientation

System Menu

• In the DVI section (applies to ImagePRO Aux destinations only):

~ DVI Router Name — selects the router from which DVI sources will be

routed to the ImagePRO.

~ DVI Router Output — selects the specific router output designated as

Aux (as assigned on the router’s

Output Patch Menu).

~ ImagePRO Input — selects the ImagePRO input to which the DVI

router output is connected.

• Press {RESET} to return all fields to <UNDEFINED>.

Please note the following important points regarding Aux destinations:

• For proper operation, ImagePRO and PrePRO-II devices must be connected to

the ScreenPRO-II Controller via Ethernet.

• ImagePRO and PrePRO-II output setups must be performed locally on the units

themselves.

• Only one router of each type (Analog, DVI and SDI) can be connected to an

ImagePRO unit.

• Only one Analog and one SDI router can be connected to a PrePRO-II unit.

• In order to properly create “source files” on ImagePRO:

~ On the ScreenPRO-II Controller console, select a ScreenPRO-II

Controller destination.

~ On the Input Menu, acquire the selected source in the normal manner.

~ Press {SAVE} to save the source in the normal manner, which in turn

also creates a source file on the ImagePRO.

~ Repeat for all desired sources.

Note

The “copy down” of source file information is possible

because the system “knows” that ImagePRO is connected to

the same router from which the newly acquired input

originates — all based on the patching configuration.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 291 292

No comments

Barco BlendPRO-II Instruction Manual Page 123