Barco ScreenPRO-II Instruction Manual download pdf (Page 194)

182 ScreenPRO-II • User’s Guide

aK==oÉãçíÉ=`çåíêçä

Using Remote Control

9. (Optional) If required, press {DELETE PATCH} to delete the current patch — in

case you need to start again, or re-define the patch.

10. Repeat from step 5 for all remaining outputs for the currently selected router.

11. Press {BACK} to return to the Router Specification Menu.

12. To select the next router whose outputs you wish to patch, repeat from step 3 .

Please continue with the “

Input Patching” section on page 182.

fåéìí=m~íÅÜáåÖ

The input patch procedure enables you to associate specific router inputs with specific

source buttons on the Controller.

 Use the following procedure to set up each router’s input patching.

1. On the Encore or ScreenPRO-II Controller console, press SYSTEM > {INPUT

PATCH

} to display the Input Patch Menu, a sample of which is shown below:

Figure D-10. Input Patch Menu (sample)

2. Scroll to the Source Number line and select the source button on the Controller

that you want to patch.

Note

This procedure is required for both “Internal” and “External”

source routing on your ScreenPRO-II units.

INPUT SOURCE PATCH

Source Number 1

DELETE

PATCH

MATRIXPRO1Connection Type

1Router Input

ADD

PATCH

Note

The Controller is pre-programmed with a series of default

input patches. For example, the first connected router will be

assigned the first series of inputs (e.g.,

1 - 12 on the

Controller SC); the second router will be assigned the next

series of inputs (e.g.,

13 - 24). You may elect to keep these

defaults, or “re-patch” as required.

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 205 206

No comments

Barco ScreenPRO-II Instruction Manual Page 194