Barco ScreenPRO-II Instruction Manual download pdf (Page 145)

ScreenPRO-II • User’s Guide 133

6. Operations

Using Move

mêçÖê~ã=jçîÉ=çå=mêçÖê~ã=jÉíÜçÇ

This mode enables you to program a move with the image on both Program and Preview

— after a layer has transitioned to Program. When you press

Move Setup to change a

layer’s size and position, only the

raster box moves — rather than the entire image.

 Use the following steps to program a move on Program:

1. In the Layer Control Section, select the layer (on Program) that you want to

move (

A or B). The button blinks to indicate that it is active for modification. Note

that its current position is the move’s "starting" location.

2. In the Mixer Functions Section, press Move Setup. The button blinks to

indicate that you are now actively defining a move property.

3. Size and position the PIP or Key to its “ending” location. Note that on Preview,

only the raster box moves.

4. Press Move Setup again to complete the programming. The button remains lit

solid, and the raster box returns to its starting location on Preview.

5. To set up an additional move (provided that you are in Split Layer mode), repeat

the procedure from step 1.

To pend and trigger the move, refer to the "

Pending and Triggering Moves" section.

mÉåÇáåÖ=~åÇ=qêáÖÖÉêáåÖ=jçîÉë

For each layer on which you have programmed an associated move, you can “pend” and

"trigger" the move in one of two ways — on

Preview or on Program.

• Pend on Preview Method

• Pend on Program Method

mÉåÇ=çå=mêÉîáÉï=jÉíÜçÇ

This "move" method enables you to move the PIP or Key automatically on the next

transition.

 Use the following steps to pend a move on Preview:

1. With the move properly programmed, ensure that the layer containing a move is

selected and blinking.

2. To pend the move, press Move in the Mixer Functions Section. The button

lights to indicate the pending move, and on Preview, the raster box blinks at the

"destination" location —

not the PIP or Key’s current location.

3. Perform a MIX, CUT or WIPE. The transition takes the Preview image to air, and

the move begins immediately on both Program and Preview.

4. To move the layer back to keyframe 1, press Move. The button lights and on

Preview, the raster box blinks at the "starting" location.

5. Perform a MIX, CUT or WIPE. In this "ping-pong" manner, you can continue to

transit back and forth between keyframes 1 and 2.

Note

The move rate cannot be adjusted while the layer is on

Program.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 205 206

Comments to this Manuals

No comments

Barco ScreenPRO-II Instruction Manual Page 145

Comments to this Manuals

Related products and manuals for TVs & monitors Barco ScreenPRO-II