Barco ScreenPRO-II Instruction Manual download pdf (Page 140)

128 ScreenPRO-II • User’s Guide

6. Operations

Working with Layers

8. Special Effects — From the Matte Menu, press {EFX} to display the Image

Effects Menu

. Use the menu to select monochrome or color mode, to modify

chroma and hue, to invert the color, and to set a strobe effect. In Chapter 4, refer

to the "

Image Effects Menu" section on page 73 for menu details.

9. Global Functions — Remember that the following global functions are always

available to you:

~ Press Reset to reset the current effect (e.g., PIP, Key, crop, etc.) to a

nominal default value.

~ Press Full Screen to bring the Key to full screen, using the source’s

height as the defining factor.

~ Press Freeze to freeze the Key (on both Program and Preview). Press

again to unfreeze.

10. Transition — Transition the new "look" to program with a MIX, WIPE or CUT.

Refer to the “

Working with Transitions“ section on page 135 for details.

`äÉ~êáåÖ=i~óÉêë=Ñêçã=mêçÖê~ã

The "clear layer" procedure enables you to remove layers from Program. By comparing

your Program and Preview monitors and creating the desired look on Preview, you will

you’ll always know what PIPs and keys to you wish to clear. Refer to the "

Lookahead

Preview" section on page 118 for additional details.

 Use the following steps to clear a layer from Program:

1. Check (and compare) the Program and Preview monitors, and note the layer(s)

that you wish to clear. In the

Layer Control Section, Red LEDs above buttons

indicate layers that are on Program.

2. If the button for the layer that you wish to clear is not lit, press to light it — and

ensure the button is blinking.

3. In the Mixer Functions Section, press Clear Layer. This action causes the layer

button to extinguish, and its layer to clear from Preview. This step is valid for all

buttons in the

Layer Control Section.

4. Prior to the transition, if you want to clear additional layers from Preview, repeat

steps

2 and 3.

5. Transition the new "look" to program with a MIX, WIPE or CUT. The selected

layer(s) will transition off of Program.

Clear

Layer

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 205 206

Comments to this Manuals

No comments

Barco ScreenPRO-II Instruction Manual Page 140

Comments to this Manuals

Related products and manuals for TVs & monitors Barco ScreenPRO-II