Barco MIVD 1218 User Manual download pdf (Page 10)

User manual MIVD 1218

To remove the strap:

1 Position the display with its rear side facing you.

2 If the foot cover is mounted on the foot, lift up the 2 clips of the

foot cover to release the cover from the foot.

3 Pull the lower side of the cover towards you and simultaneously

slide the cover downward.

4 Pull the red strap out of the fixation holes in the foot.

To change the panel orientation:

1 Stand at the front side of the panel and take the panel at both

sides.

2 Very important: Tilt the panel before changing

the orientation.

Should you change the panel orientation without

tilting it first, you might irreversibly damage the

tilt & swivel mechanism.

3 To change from portrait to landscape, turn the

panel counterclockwise while tilting it slightly.

To change from landscape to portrait, turn clockwise.

2.4. Connecting the signals

To get access to the connectors, open the cover of the connector

compartment by pulling down the 2 clips of the cover.

To connect DVI signals:

1 Connect one end of the DVI cable to the DVI input (5) of the

display.

2 Connect the other end of the DVI cable to the video output of your

DVI signal source.

3 Rout the cable so that it enters the connector compartment at the

place where the cover is bulged.

Strap

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

No comments

Barco MIVD 1218 User Manual Page 10