Barco MFGD-5421 User Manual download pdf (Page 37)

Installation

Figure 15

Should you change the panel orientation without tilting it

first, you might irreversibly damage the tilt & swivel

mechanism.

3. To change from portrait to landscape, turn the panel

counterclockwise while tilting it slightly.

4. To change from landscape to portrait, turn clockwise.

Connecting the cables

To get access to the connectors, open the cover of the connector

compartment by pulling down the 2 clips of the cover.

The signal cables can be routed inside the display foot. Therefore,

remove the foot cover before connecting the cables (see "Before

installing the display").

To connect DVI cables:

1. Connect one end of the DVI cable to the DVI input (6) of the

display.

2. Connect the other end of the DVI cable to the video output of

your DVI signal source.

3. Route the cable so that it enters the connector compartment

at the place where the cover is bulged.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 111 112

No comments

Barco MFGD-5421 User Manual Page 37