Barco Coronis 5MP Mammo User Manual download pdf (Page 73)

Barco DPMS Screen Saver

Introduction

The BARCO DPMS (Display Power Management Signaling) Screen Saver

allows the user to set power and display saving features for medical

displays controlled by BarcoMed Display Controllers. At the end of the

work day, the display will enter certain DPMS states as requested by the

display controller.

Note: The Barco DPMS Screen Save will not

control any displays

connected to a non-Barco display controller.

The default state for the BARCO DPMS Screen Saver is the Off state. In

addition to simply entering the Off state after the work day, the user can

specify that the display first go through two other DPMS Screen Saver

states before going into Off state. These two other states for the Screen

Saver are Stand-By and Suspend. The user can specify how much time

should be spent in each state in the “Amount of Time in each DPMS

Power State” section.

On Barco CORONIS displays, the I-GUARD will stabilize the image within

a few seconds after the display returns to the active state, thus

eliminating the need for a warm-up period at the beginning of the work

day.

On Liquid Crystal Display (LCD) based displays, such as the Barco

CORONIS displays, it is not necessary to invoke a screen saver as there is

no CRT phosphor to preserve. However, one can extend the life of the

backlight in the LCD display, in addition to realizing great power savings,

during period of user inactivity by using DPMS to quickly enter the Off

state. We recommend setting the work day to be as short as possible to

get the maximum power savings on CORONIS displays.

The BARCO DPMS Screen Saver can also be used when no one is logged

on.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 151 152

No comments

Barco Coronis 5MP Mammo User Manual Page 73