Barco Coronis 5MP Mammo User Manual download pdf (Page 126)

Display resolution

126

Setting the resolution of your Coronis 5MP

Mammo display

In order to set the resolution of your Coronis 5MP Mammo display

you must be logged in using an account with administrator

privileges.

1. To set the resolution of your Coronis 5MP Mammo display(s) right

click on the desktop and select “Properties”.

2. Select the “Settings” tab.

3. Select the rectangle that represents the first Coronis 5MP Mammo

display attached to the BarcoMed 5MP2FH Display Controller you

are working with.

NOTE: If you are using the VGA capabilities of your BarcoMed

5MP2FH Display Controller, the resolution for the first display may

be set to a VGA resolution of “640 x 480” pixels with 16 colors and

a default refresh rate. If your BarcoMed 5MP2FH controller is not

running VGA, the display may not be enabled yet. To enable the

display, check the “Extend my Windows desktop onto this

monitor” checkbox, but do NOT

click the “Apply” button at this

time.

If you installed your BarcoMed 5MP2FH drivers in SingleView

mode (default for Windows 2000) there will be one rectangle for

the virtual display representing the two heads controlled by each

BarcoMed 5MP2FH display controller.

If you installed your BarcoMed 5MP2FH drivers in DualView mode

(default for Windows XP) there will be a rectangle representing

each head controlled by each BarcoMed 5MP2FH display controller.

This will be true even if you have only one display connected to

your BarcoMed 5MP2FH controller. Both displays of a display

controller cannot be enabled at the same time unless their display

properties match. If necessary detach the second display of the

BarcoMed 5MP2FH Display Controller you are working with by

right clicking on the rectangle that represents it, deselect

“Attached” and click the “Apply” button.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 151 152

No comments

Barco Coronis 5MP Mammo User Manual Page 126