8. Service Mode
To adjust the light output in case of a single, stand alone projector setup, set the CLO setting to [SLAVE].
8.8.3 Lamp Mode
What can be done?
The Lamp can be set to the normal or economic mode.
How to change the Lamp Mode Setting?
1. Push the cursor key ↑ or ↓ to highlight Mode. (menu 8-16)
2. Press ENTER to toggle between the different Mode settings.
Following Mode Settings are available:
[NORMAL] Normal Light Output
[ECONOMIC] Reduced Light Output
Table 8 -3
(Lamp) Mode Settings
LAMP
CONSTANT LIGHT OUTPUT [MASTER]
MODE [NORMAL]
_________________________________
Serial number : 003706
Article number : R9840740
Run time : 140 hours
Remaining run time : 1360
hours
Number of strikes : 160
Z-axis : 100 units
_______________________________
__
Select with ↑ or ↓
<ENTER> to toggle
<EXIT> to return
Menu 8-16
8.9 Barco Logo
8.9.1 Starting Up Barco Logo
What can be done?
The Barco Logo can be added to the projected image, in overlay or on a background, on any place on the screen.
How to Start Up the Barco Logo?
1. Push the cursor key ↑ or ↓ to highlight More. (menu 8-17)
2. Press ENTER to select.
The other items in
the Service menu will be displayed.
3. Push the cursor key ↑ or ↓ to highlight Barco Logo. (menu 8-18)
4. Press ENTER to select.
The Barco Logo menu will be displayed. (menu 8-19)
SERVICE
IDENTIFIC
ATION
CHANGE PASSWORD
CHANGE PROJ. ADDRESS
CHANGE BAUDR
ATE PC
LAMP
MORE ...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-17
SERVICE
BARCO LOGO
PRESET INPUT BALANCE 1
PRESET INPUT BALANCE 2
ELECTRONIC C
ONVERGENCE
DIAGNOSIS
DYNACOLOR
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-18
BARCO LOGO
STATUS [OF
F]
BACKGROUND [OFF]
SHIFT
HOT KEY [OFF]
Select with ↑ or ↓
<ENTER> to toggle/select
<EXIT> to return
Menu 8-19
136 R5976570 BARCO GALAXY WARP™ 25/03/2004
Comments to this Manuals