8. Service Mode
8.6.1 Starting Up Change Projector Address
How to Start Up Change Projector Address?
1. Push the cursor key ↑ or ↓ to highlight Change Proj Ad dress. (menu 8-7)
2. Press ENTER to select.
The Change Projector Address menu will be displayed. (menu 8-8)
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
LAMP
MORE ...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-7
CHANGE PROJECTOR ADDRESS
PROJECTOR ADDRESS 6
COMMON ADDRESS (RC5) 0
COMMON ADDRESS (PPM) 0
Select with ↑ or ↓
then <ENTER>
Reprogram with ↑,↓,←,→
or numeric keys
<ENTER> to confirm
<EXIT> to return
Menu 8-8
8.6.2 Changing the Projector Address
How to Change the Projector Address?
1. Push the cursor key ↑ or ↓ to highlight Projector Address. (menu 8-9)
2. Press ENTER to select.
The actual address is filled in.
The first digit is highlighted.
CHANGE PROJECTOR ADDRESS
PROJECTOR ADDRESS 6
COMMON ADDRESS (RC5) 0
COMMON ADDRESS (PPM) 0
Select with ↑ or ↓
then <ENTER>
Reprogram with ↑,↓,←,→
or numeric keys
<ENTER> to confirm
<EXIT> to return
Menu 8-9
How to Enter the new Projector Address?
1. Enter the digits with the digit keys on the RCU or local keypad.
Or,
push the cursor keys ← or → to select a digit and change the value by pushing the cursor key ↑ or ↓ until the new value is reached.
Continue with the other digits on the same way. The individual address must be between 0 and 255.
In a Linked CLO and/or Dynacolor™ setup a maximum of 14 projectors can be linked, all projectors must have
a different projector address between 0 and 13.
132 R5976570 BARCO GALAXY WARP™ 25/03/2004
Comments to this Manuals