Barco R9002327 Installation Manual download pdf (Page 26)

INSTALLATION SET UP

4-7

INSTALLATION SET UP

4-7

INSTALLATION SET UP

5975069A BARCOVISION 708 200498

After scan inversion, close the chassis and close the top cover. Reconnect the

power cord to the wall outlet.

Note

Switching over from floor to ceiling or vice versa requires a complete readjustment

of picture geometry and convergence.

Check of the correct connector position

Note : this check procedure can only be done after power (mains) connection. So,

first continue with the projector set up and the connections and then return to this

checking procedure.

Switch on the BARCOVISION 708 MULTIMEDIA and press ADJUST to start up the

adjustment mode. Select with the control disc 'Service' and press ENTER. The

service menu will be displayed. Select 'PROJECTOR SET UP' and press ENTER. Select

'IDENTIFICATION' and press ENTER. On this screen, information is given about the

projectors configuration.

Configuration when leaving the factory : ceiling/front configuration.

Follow next procedure to check the configuration :

- switch on the projector.

- the projector starts up on the last

selected source.

- press the ADJUST key.

- highlight 'service' with the control

disc and press ENTER.

The 'service mode menu' will be dis-

played

- select with the control disc 'Projector

set up' and press ENTER.

Select with or

then <ENTER>

<EXIT> to return.

SERVICE MODE

PROJECTOR SETUP

MEMORY MANAGEMENT

COMMON SETTINGS

I²C DIAGNOSTICS

After scan inversion, close the chassis and close the top cover. Reconnect the

power cord to the wall outlet.

Note

Switching over from floor to ceiling or vice versa requires a complete readjustment

of picture geometry and convergence.

Check of the correct connector position

Note : this check procedure can only be done after power (mains) connection. So,

first continue with the projector set up and the connections and then return to this

checking procedure.

Switch on the BARCOVISION 708 MULTIMEDIA and press ADJUST to start up the

adjustment mode. Select with the control disc 'Service' and press ENTER. The

service menu will be displayed. Select 'PROJECTOR SET UP' and press ENTER. Select

'IDENTIFICATION' and press ENTER. On this screen, information is given about the

projectors configuration.

Configuration when leaving the factory : ceiling/front configuration.

Follow next procedure to check the configuration :

- switch on the projector.

- the projector starts up on the last

selected source.

- press the ADJUST key.

- highlight 'service' with the control

disc and press ENTER.

The 'service mode menu' will be dis-

played

- select with the control disc 'Projector

set up' and press ENTER.

Select with or

then <ENTER>

<EXIT> to return.

SERVICE MODE

PROJECTOR SETUP

MEMORY MANAGEMENT

COMMON SETTINGS

I²C DIAGNOSTICS

Select with or

then <ENTER>

<EXIT> to return.

ADJUSTMENT MODE

Select a path from below :

GUIDED

RANDOM ACCESS

INSTALLATION

SERVICE

IRIS

Source 1

Select with or

then <ENTER>

<EXIT> to return.

ADJUSTMENT MODE

Select a path from below :

GUIDED

RANDOM ACCESS

INSTALLATION

SERVICE

IRIS

Source 1

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 54 55

Comments to this Manuals

No comments

Barco R9002327 Installation Manual Page 26

Comments to this Manuals

Related products and manuals for Projectors Barco R9002327