Barco MGP 15 Dicom Theater User Manual download pdf (Page 29)

Display controller installation

figure 7 below). By default, VGA should be enabled, switch 1 on

and switch 2 off. If you decide to use a separate VGA monitor as

your boot monitor, you must disable the BarcoMed 2MP2CP’s on-

board VGA capabilities by changing the switch settings to switch

1 off and switch 2 on.

Figure 7

In figure 7 above, the VGA capabilities of the BarcoMed 2MP2CP

are enabled.

Caution: To use multiple BarcoMed 2MP2CP controllers in a

single host with VGA enabled, you should enable

VGA on only

ONE of the BarcoMed 2MP2CP display controllers and disable

VGA

on ALL the other BarcoMed 2MP2CP display controllers.

Examples of PCI slots

The BarcoMed 2MP2CP display controller may be installed in

either a 32-bit or 64-bit slot with no loss of functionality.

Figure figure 8 on page 30 illustrates the types of slots so that

you can correctly identify which one to use for the

BarcoMed 2MP2CP display controller and which ones not to use.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 101 102

No comments

Barco MGP 15 Dicom Theater User Manual Page 29