Barco R9002327 Installation Manual download pdf (Page 47)

INSTALLATION ADJUSTMENTS

7-14

INSTALLATION ADJUSTMENTS

7-14

INSTALLATION ADJUSTMENTS

5975069A BARCOVISION 708 200498

CRT projection angle adjustment

The projection angle of the red and blue CRT's is dependent on the desired size of

the projected image. If the centers of green, blue and red do not coincide, the CRT

projection angle must be adjusted. Never try to correct this misalignment with the shift

correction or the static convergence controls. These controls may only be applied

to correct small errors which cannot be corrected by the CRT angle adjustment.

Ensure that the rasters are centered on

the CRT face.

Press ENTER to start the CRT angle

adjustment procedure. A crosshairs

(green and red) will be displayed on the

screen.

ENTER continues with the second part

EXIT returns to raster shift adjustment

ADJUST returns to operational mode.

Loosen the four hexagon screws A, A',

B and B', upper and lower fixation latch.

of the CRT projection angle adjustment.

EXIT returns to Raster shift adjustment.

ENTER continues to the crosshairs align-

ment.

CRT PROJECTION ANGLE

ADJUSTMENT

<ENTER> to read more

<EXIT> to return

CRT PROJECTION ANGLE IS

THE FIRST STEP OF STATIC

CONVERGENCE ADJUSTMENT.

IT IS CRITICAL THAT THE

RASTERS ARE CENTERED ON

THE CRT FACE PLATES

PRIOR TO PERFORMING

THIS STEP.

...

CRT PROJECTION ANGLE

ADJUSTMENT

<ENTER> to continue

<EXIT> to return

DURING THIS PROCEDURE,

RED ON GREEN AND THEN

BLUE ON GREEN CROSSHAIRS

WILL BE DISPLAYED

TO ALLOW THE RED AND

BLUE CRTS TO BE ALIGNED

WITH THE GREEN CRT.

LOOSEN BOLTS A AND B

TO PIVOT THE RED CRT,

AND BOLDS C AND D

TO PIVOT THE BLUE CRT.

CRT projection angle adjustment

The projection angle of the red and blue CRT's is dependent on the desired size of

the projected image. If the centers of green, blue and red do not coincide, the CRT

projection angle must be adjusted. Never try to correct this misalignment with the shift

correction or the static convergence controls. These controls may only be applied

to correct small errors which cannot be corrected by the CRT angle adjustment.

Ensure that the rasters are centered on

the CRT face.

Press ENTER to start the CRT angle

adjustment procedure. A crosshairs

(green and red) will be displayed on the

screen.

ENTER continues with the second part

EXIT returns to raster shift adjustment

ADJUST returns to operational mode.

Loosen the four hexagon screws A, A',

B and B', upper and lower fixation latch.

of the CRT projection angle adjustment.

EXIT returns to Raster shift adjustment.

ENTER continues to the crosshairs align-

ment.

CRT PROJECTION ANGLE

ADJUSTMENT

<ENTER> to read more

<EXIT> to return

CRT PROJECTION ANGLE IS

THE FIRST STEP OF STATIC

CONVERGENCE ADJUSTMENT.

IT IS CRITICAL THAT THE

RASTERS ARE CENTERED ON

THE CRT FACE PLATES

PRIOR TO PERFORMING

THIS STEP.

...

CRT PROJECTION ANGLE

ADJUSTMENT

<ENTER> to continue

<EXIT> to return

DURING THIS PROCEDURE,

RED ON GREEN AND THEN

BLUE ON GREEN CROSSHAIRS

WILL BE DISPLAYED

TO ALLOW THE RED AND

BLUE CRTS TO BE ALIGNED

WITH THE GREEN CRT.

LOOSEN BOLTS A AND B

TO PIVOT THE RED CRT,

AND BOLDS C AND D

TO PIVOT THE BLUE CRT.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 53 54 55

Comments to this Manuals

No comments

Barco R9002327 Installation Manual Page 47

Comments to this Manuals

Related products and manuals for Projectors Barco R9002327