Barco MGP 15 Dicom Theater Instruction Manual download pdf (Page 40)

5. Getting started

Why a projector address ?

As more than one projector can be installed in a room, the separate projector should be separately addressable with an RCU or

computer. Therefor each projector has its own address.

Set up an individual Projector Address.

The set up of a projector address can be done via the software.

Projector controlling.

Every projector requires an individual address between 0 and 255 which can be set in the Installation menu.

Whentheaddressisset,theprojectorcanbecontrolledby:

• RCU for addresses between 0 and 9.

• computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between 0 and 255.

A projector will respond to a RCU set to the common address ’0’ regardless of what address is set in the projector itself (common

address of projector should also be “0” ).

The RCU is default programmed with address 0 , ’common address’.

If it is necessary to control a specific projector, then enter the projector address into the RCU (only when that

address is between 0 and 9). The projector with the corresponding address will listen to that specific RCU.

Some projectors may operate in domestic environments where other equipments may listen to the common

address “0” , therefore the common address can also be set to “1”.

5.7.2 Displaying and Programming addresses into the RCU

Displaying the Projector Address on the Screen.

1. Press the Address key (recessed key on the RCU) with a pencil.

The projector’s address will be displayed in a ’Text box’

To continue using the RCU with that specific address, it is necessary to enter the same address with the

digit buttons (address between 0 and 9) within 5 seconds after pushing the address key. For example : if the

Address key displays projector address 003, then press "3" digit button on the RCU to set the RCU’s address

to match the projector’s address. Do not press 0–0–3 . This will address the remote control to ’0’ and control

all projectors in the room. If the address is not entered within 5 seconds, the RCU returns to its default address

(zero address) and controls then all projectors in the room.

Address 0 (or 1) should always allow communication with the projector since it is a common address.

Displaying the Projector Address in Standby.

1. Press the Address key (recessed key on the RCU) with a pencil.

All the LED’s on the front of the projector go out.

Then LED1 starts blinking green the number of hundreds. Afte

r that LED2 starts blinking the number of tens. Finally LED3 starts

blinking green the number of units. If this is done, the original status of the leds is restored.

5.8 Digital Zoom

What can be done ?

The Digital Zoom key on the RCU allows to zoom (in or out) one particular part of the image

How to Zoom ?

1. Press ← or → on the Digital Zoom key on the remote to Zoom the center of the image

A wizardbox is displayed in the lower part of the screen, follow the instructions.

Use the BACK key to undo the Zoom function.

R5976741 MGP 15 MEDICAL GRADE PROJECTOR 28/04/2004

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 133 134

Comments to this Manuals

No comments

Barco MGP 15 Dicom Theater Instruction Manual Page 40

Comments to this Manuals

Related products and manuals for Projectors Barco MGP 15 Dicom Theater